Crown Molding Gap Ceiling

Here's a crown molding gap at the ceiling. The red arrows point to the ugly gaps. See below how to avoid and fix them. Copyright 2018 Tim Carter

Crown Molding Gap at Ceiling - Carpenters Goofed Up

Charlie from Easley, SC has a crown molding gap where it meets the ceiling. I have the same issue at my own home.

It's important to realize he’s got crown molding in at least one room of his home and in the winter months a gap appears between the top of the crown molding and the ceiling.

He felt it was a temperature-change issue, and in some ways he’s correct. However, it’s important to realize the temperature in his home is very likely fairly consistent month to month. Perhaps it varies by eight to ten degrees.

Related Links

Lumber Shrinkage Facts and Secrets

Installing Fancy Crown Molding - Stunning Inside and Outside Corners

Free & Fast Bids

CLICK HERE to get FREE & FAST BIDS from local painters who can caulk the ceiling gap.

Rough Lumber Shrinkage is the Cause of Crown Molding Gap

Another key point is the outside temperature and humidity is much different in South Carolina during the year. As the air cools down during winter months, it holds much less humidity.

The lumber in Charlie’s, and my, house dries out and shrinks. This rough-framing lumber shrinkage is the source of our joint woes.

Nail Crown to Ceiling to Avoid Gaps

The problem could have been prevented had the carpenters that installed the crown molding attached it to the ceiling instead of the wall studs. The foot of the crown molding would then just ride up and down the wall surface as the lumber expands and contracts with the change of seasons.

A simple triangular block of rough lumber that just about fills the void space behind the crown molding could have been nailed to the ceiling joists on two walls and blocking on the other two. The crown molding would then be nailed to this wood with the nails aiming up towards the ceiling.

Crown molding gaps at ceilings can be eliminated if you attach the crown molding this way. NO nails should enter the wall studs or top plate. Note the blue triangular block that is custom cut to fill the void behind the crown molding. Nail it to the ceiling joists or blocking in lieu of joists. Then nail the crown molding up through the triangular block into the ceiling. Copyright 2018 Tim Carter

Charlie’s best chance of fixing the crack without reinstalling the crown molding, a huge pain in the keister, is to caulk the gaps in the middle of winter when the gap between the molding and the ceiling is the greatest. I’m going to fix mine by using the most expensive caulk I can locate that has the greatest amount of long-term flexibility.

Six months from now the caulk seam may squeeze out of the gap a little bit, but come next winter if the caulk performs as expected, there will be no gap.

CLICK HERE to get FREE & FAST BIDS from local painters who can caulk the ceiling gap.

The post Crown Molding Gap Ceiling appeared first on Ask the Builder.

Via builders feed http://www.rssmix.com/